德国aircom详细说明
描述:
Description:
Closed loop electronic pressure regulator consisting of two
solenoid valves, an internal pressure transducer, and an
electronic control circuit mounted to an integral volume
booster. The pressure is controlled by activating the
solenoid valves, which apply pressure to the pilot side of
the volume booster.
Single_loop:
Pressure is controlled by two solenoid valves. One valve
functions as inlet control, the other as exhaust. The pressure
outlet is measured by an internal pressure transducer which
provides a feedback signal to the electronic controls.
This feedback signal is compared with the command input signal.
Any difference between the two signals causes one of the two
solenoid valves to open, allowing flow into or out of the system.
Accurate pressure is maintained by these two valves.
Media: dry, unlubricated and 5 μm filtered compressed air or non-corrosive gases
Pressure_range: -1... 35 bar
Accuracy: +/- 0.4%
Input_signal: 0-10 V; 4-20 mA
Mounting_position: any
Protection_class: IP65
Adjustment: zero point, span, hysteresis
Response_time: 15 ... 20 ms
Air_consumption: without constant bleed
Power_consumption: 6 W
Temperature_range: 0 °C to 70 °C / 32 °F to 158 °F
Booster_body: nickel-plated aluminium
Elastomer: FKM, NBR/Buna-N
Transducer: aluminium and silicon
Valves: nickel-plated brass
德国aircom型号大全
R13-02EV流量计
AirCom PRA32-0600
F465-06EL过滤器
特价供应 AirCom 调压阀 B20-08WJC
FM-03_02过滤器
特价供应 AirCom 调压阀 R160-04B03
AirCom 压力调节器（减压阀） R03-04D
R13-02EV减压阀
R160-04C15_01减压阀
MHA-B2P风压表
AirCom 压力表 MHA-10
AirCom R102-12A
AirCom 10262HB
AirCom 阀 R03-04J
特价供应 AirCom 调压阀 F445-08GL
F602-16EJ过滤器
特价供应 AirCom 调压阀 F602-12EJ 1-1/2"NPT
特价供应 AirCom 调压阀 R120-08F
R13-02EV减压阀
AirCom 阀门附件 MA6302-02
德国aircom品牌介绍
德国AirCom公司压力变送器工作原理：当压力直接作用在测量膜片的表面，使膜片产生微小的形变，测量膜片上的高精度电路将这个微小的形变变换成为与压力成正比的高度线性、与激励电压也成正比的电压信号，然后采用专用芯片将这个电压信号转换为工业标准的4-2OmA电流信号或者1-5V电压信号。由于测量膜片采用标准话集成电路，内部包含线性及温度补偿电路，所以可以做到高精度和高稳定性，变送电路采用专用的两线制芯片，可以保证输出两线制4-2OmA电流信号。德国AIRCOM压力变送器主要性能：1、使用被测介质广泛，可测油、水及与316不锈钢和304不锈钢兼容的糊状物，具有 定的防腐能力；2、高准确度、高稳定性、选用进口原装传感器，线性好，温度稳定性高；3、体积小、重量轻、安装、调试、使用方便；4、不锈钢全封闭外壳，防水好；5、压力传感器直接感测被测液位压力，不受介质起泡、沉积的影响。
描述:
Description:
Closed loop electronic pressure regulator consisting of two
solenoid valves, an internal pressure transducer, and an
electronic control circuit mounted to an integral volume
booster. The pressure is controlled by activating the
solenoid valves, which apply pressure to the pilot side of
the volume booster.
Single_loop:
Pressure is controlled by two solenoid valves. One valve
functions as inlet control, the other as exhaust. The pressure
outlet is measured by an internal pressure transducer which
provides a feedback signal to the electronic controls.
This feedback signal is compared with the command input signal.
Any difference between the two signals causes one of the two
solenoid valves to open, allowing flow into or out of the system.
Accurate pressure is maintained by these two valves.
Media: dry, unlubricated and 5 μm filtered compressed air or non-corrosive gases
Pressure_range: -1... 35 bar
Accuracy: +/- 0.4%
Input_signal: 0-10 V; 4-20 mA
Mounting_position: any
Protection_class: IP65
Adjustment: zero point, span, hysteresis
Response_time: 15 ... 20 ms
Air_consumption: without constant bleed
Power_consumption: 6 W
Temperature_range: 0 °C to 70 °C / 32 °F to 158 °F
Booster_body: nickel-plated aluminium
Elastomer: FKM, NBR/Buna-N
Transducer: aluminium and silicon
Valves: nickel-plated brass
德国aircom型号大全
R13-02EV流量计
AirCom PRA32-0600
F465-06EL过滤器
特价供应 AirCom 调压阀 B20-08WJC
FM-03_02过滤器
特价供应 AirCom 调压阀 R160-04B03
AirCom 压力调节器（减压阀） R03-04D
R13-02EV减压阀
R160-04C15_01减压阀
MHA-B2P风压表
AirCom 压力表 MHA-10
AirCom R102-12A
AirCom 10262HB
AirCom 阀 R03-04J
特价供应 AirCom 调压阀 F445-08GL
F602-16EJ过滤器
特价供应 AirCom 调压阀 F602-12EJ 1-1/2"NPT
特价供应 AirCom 调压阀 R120-08F
R13-02EV减压阀
AirCom 阀门附件 MA6302-02
德国aircom品牌介绍
德国AirCom公司压力变送器工作原理：当压力直接作用在测量膜片的表面，使膜片产生微小的形变，测量膜片上的高精度电路将这个微小的形变变换成为与压力成正比的高度线性、与激励电压也成正比的电压信号，然后采用专用芯片将这个电压信号转换为工业标准的4-2OmA电流信号或者1-5V电压信号。由于测量膜片采用标准话集成电路，内部包含线性及温度补偿电路，所以可以做到高精度和高稳定性，变送电路采用专用的两线制芯片，可以保证输出两线制4-2OmA电流信号。德国AIRCOM压力变送器主要性能：1、使用被测介质广泛，可测油、水及与316不锈钢和304不锈钢兼容的糊状物，具有 定的防腐能力；2、高准确度、高稳定性、选用进口原装传感器，线性好，温度稳定性高；3、体积小、重量轻、安装、调试、使用方便；4、不锈钢全封闭外壳，防水好；5、压力传感器直接感测被测液位压力，不受介质起泡、沉积的影响。
QQ：1325426082广告业务:
